HP MSA2000 Error Event 313

MSA.Rule.Event.System.Error.313 (Rule)

The indicated controller module has failed.

Knowledge Base article:

Summary

Error Event 313.

Causes

The indicated controller module has failed. This event can be ignored for a single-controller configuration.

Resolutions

It this is a dual-controller system, replace the failed controller module. The module’s Fault/Service Required LED will be illuminated (not blinking).

Element properties:

Target

MSA.System

Category

Alert

Enabled

True

Alert Generate

True

Alert Severity

Error

Alert Priority

Low

Remotable

False

Alert Message

The indicated controller module has failed.

System Name: {0}
Primary IP Address: {1}
Secondary IP Address: {2}
Severity: {3}
Event: {4}

Member Modules:

ID	Module Type	TypeId	RunAs
Event	DataSource	MSA.DataSource.Event.System	Default
EventFilter	ConditionDetection	MSA.ConditionDetection.Filter.Event	Default
Alert	WriteAction	System.Health.GenerateAlert	Default

Source Code:

<Rule ID="MSA.Rule.Event.System.Error.313" Enabled="true" Target="MSA.System" ConfirmDelivery="true" Remotable="false" Priority="Normal" DiscardLevel="100">

  <Category>Alert</Category>

  <DataSources>

    <DataSource ID="Event" TypeID="MSA.DataSource.Event.System"/>

  </DataSources>

  <ConditionDetection ID="EventFilter" TypeID="MSA.ConditionDetection.Filter.Event">

    <EventCode>313</EventCode>

    <SeverityNumeric>1</SeverityNumeric>

  </ConditionDetection>

  <WriteActions>

    <WriteAction ID="Alert" TypeID="Health!System.Health.GenerateAlert">

      <Priority>0</Priority>

      <Severity>2</Severity>

      <AlertMessageId>$MPElement[Name="AlertMessageID0b0212ac4a894a398bd4dc63193e664d"]$</AlertMessageId>

      <AlertParameters>

        <AlertParameter1>$Target/Property[Type="System!System.Entity"]/DisplayName$</AlertParameter1>

        <AlertParameter2>$Target/Property[Type="MSA.System"]/PrimaryIP$</AlertParameter2>

        <AlertParameter3>$Target/Property[Type="MSA.System"]/SecondaryIP$</AlertParameter3>

        <AlertParameter4>$Data/Property[@Name='severity']$</AlertParameter4>

        <AlertParameter5>$Data/Property[@Name='message']$</AlertParameter5>

      </AlertParameters>

    </WriteAction>

  </WriteActions>

</Rule>