HP MSA2000 Error Event 423

MSA.Rule.Event.System.Error.423 (Rule)

Failed to remove the indicated volume from the indicated replication set.

Knowledge Base article:

Summary

Error Event 423.

Causes

Failed to remove the indicated volume from the indicated replication set. This can occur for several reasons, such as:

The volume record is not found.
The volume record is not yet available.
A primary volume conflict exists.
You cannot delete the volume from a remote system.
You cannot remove the volume because it is the primary volume.

Resolutions

If any of the above problems exist, resolve them. Then repeat the remove operation with a valid volume.

Element properties:

Target

MSA.System

Category

Alert

Enabled

True

Alert Generate

True

Alert Severity

Error

Alert Priority

Low

Remotable

False

Alert Message

Failed to remove the indicated volume from the indicated replication set.

System Name: {0}
Primary IP Address: {1}
Secondary IP Address: {2}
Severity: {3}
Event: {4}

Member Modules:

ID	Module Type	TypeId	RunAs
Event	DataSource	MSA.DataSource.Event.System	Default
EventFilter	ConditionDetection	MSA.ConditionDetection.Filter.Event	Default
Alert	WriteAction	System.Health.GenerateAlert	Default

Source Code:

<Rule ID="MSA.Rule.Event.System.Error.423" Enabled="true" Target="MSA.System" ConfirmDelivery="true" Remotable="false" Priority="Normal" DiscardLevel="100">

  <Category>Alert</Category>

  <DataSources>

    <DataSource ID="Event" TypeID="MSA.DataSource.Event.System"/>

  </DataSources>

  <ConditionDetection ID="EventFilter" TypeID="MSA.ConditionDetection.Filter.Event">

    <EventCode>423</EventCode>

    <SeverityNumeric>1</SeverityNumeric>

  </ConditionDetection>

  <WriteActions>

    <WriteAction ID="Alert" TypeID="Health!System.Health.GenerateAlert">

      <Priority>0</Priority>

      <Severity>2</Severity>

      <AlertMessageId>$MPElement[Name="AlertMessageIDdc0f5681078f44f7b287c133874f6cf5"]$</AlertMessageId>

      <AlertParameters>

        <AlertParameter1>$Target/Property[Type="System!System.Entity"]/DisplayName$</AlertParameter1>

        <AlertParameter2>$Target/Property[Type="MSA.System"]/PrimaryIP$</AlertParameter2>

        <AlertParameter3>$Target/Property[Type="MSA.System"]/SecondaryIP$</AlertParameter3>

        <AlertParameter4>$Data/Property[@Name='severity']$</AlertParameter4>

        <AlertParameter5>$Data/Property[@Name='message']$</AlertParameter5>

      </AlertParameters>

    </WriteAction>

  </WriteActions>

</Rule>