HP MSA2000 Warning Event 168

MSA.Rule.Event.System.Warning.168 (Rule)

The indicated SES alert condition was detected in the indicated enclosure.

Knowledge Base article:

Summary

Warning Event 168.

Causes

The indicated SES alert condition was detected in the indicated enclosure.

Resolutions

Check that all modules in the enclosure are properly seated in their slots and that their latches are locked.

If the reported problem is with a power supply, perform these checks:

Check that each power supply module has its switch turned on.
Check that each power cable is firmly plugged into both the power supply and a functional electrical outlet.

If the reported problem is with a temperature sensor or fan or power supply, perform these checks:

Check that all of the enclosure's fans are running.
Check that the ambient temperature is not too warm. The enclosure operating range is 5°–40°C (41°–104°F).
Check for any obstructions to the airflow.
Check that there is a module or blank plate in every module slot in the enclosure.

If none of the above resolve the issue, the indicated FRU has probably failed and should be replaced. The failed FRU will probably have an amber LED lit.

When the problem is resolved, event 169 is logged.

Element properties:

Target

MSA.System

Category

Alert

Enabled

True

Alert Generate

True

Alert Severity

Warning

Alert Priority

Low

Remotable

False

Alert Message

The indicated SES alert condition was detected in the indicated enclosure.

System Name: {0}
Primary IP Address: {1}
Secondary IP Address: {2}
Severity: {3}
Event: {4}

Member Modules:

ID	Module Type	TypeId	RunAs
Event	DataSource	MSA.DataSource.Event.System	Default
EventFilter	ConditionDetection	MSA.ConditionDetection.Filter.Event	Default
Alert	WriteAction	System.Health.GenerateAlert	Default

Source Code:

<Rule ID="MSA.Rule.Event.System.Warning.168" Enabled="true" Target="MSA.System" ConfirmDelivery="true" Remotable="false" Priority="Normal" DiscardLevel="100">

  <Category>Alert</Category>

  <DataSources>

    <DataSource ID="Event" TypeID="MSA.DataSource.Event.System"/>

  </DataSources>

  <ConditionDetection ID="EventFilter" TypeID="MSA.ConditionDetection.Filter.Event">

    <EventCode>168</EventCode>

    <SeverityNumeric>2</SeverityNumeric>

  </ConditionDetection>

  <WriteActions>

    <WriteAction ID="Alert" TypeID="Health!System.Health.GenerateAlert">

      <Priority>0</Priority>

      <Severity>1</Severity>

      <AlertMessageId>$MPElement[Name="AlertMessageID29dc114bc10b4428bddbb72049df4433"]$</AlertMessageId>

      <AlertParameters>

        <AlertParameter1>$Target/Property[Type="System!System.Entity"]/DisplayName$</AlertParameter1>

        <AlertParameter2>$Target/Property[Type="MSA.System"]/PrimaryIP$</AlertParameter2>

        <AlertParameter3>$Target/Property[Type="MSA.System"]/SecondaryIP$</AlertParameter3>

        <AlertParameter4>$Data/Property[@Name='severity']$</AlertParameter4>

        <AlertParameter5>$Data/Property[@Name='message']$</AlertParameter5>

      </AlertParameters>

    </WriteAction>

  </WriteActions>

</Rule>