Retrying a replication due to an error on the indicated secondary volume.
Warning Event 440.
Retrying a replication due to an error on the indicated secondary volume.
This can occur for several reasons, such as:
The cache request was aborted.
The cache detected that the source or target volume is offline.
The cache detected a media error.
The snap pool is full.
The communication link is busy or experienced an error.
The snapshot being used for the replication is invalid.
There was a problem establishing proxy communication.
The replication is being automatically retried according to policies in place. If the issue is resolved before retries are exhausted, the replication will continue on its own; otherwise, it will go into a suspended state unless the policy is set up to retry forever.
If any of the above problems exist, resolve them.
Target | MSA.System | ||
Category | Alert | ||
Enabled | True | ||
Alert Generate | True | ||
Alert Severity | Warning | ||
Alert Priority | Low | ||
Remotable | False | ||
Alert Message |
|
ID | Module Type | TypeId | RunAs |
---|---|---|---|
Event | DataSource | MSA.DataSource.Event.System | Default |
EventFilter | ConditionDetection | MSA.ConditionDetection.Filter.Event | Default |
Alert | WriteAction | System.Health.GenerateAlert | Default |
<Rule ID="MSA.Rule.Event.System.Warning.440" Enabled="true" Target="MSA.System" ConfirmDelivery="true" Remotable="false" Priority="Normal" DiscardLevel="100">
<Category>Alert</Category>
<DataSources>
<DataSource ID="Event" TypeID="MSA.DataSource.Event.System"/>
</DataSources>
<ConditionDetection ID="EventFilter" TypeID="MSA.ConditionDetection.Filter.Event">
<EventCode>440</EventCode>
<SeverityNumeric>2</SeverityNumeric>
</ConditionDetection>
<WriteActions>
<WriteAction ID="Alert" TypeID="Health!System.Health.GenerateAlert">
<Priority>0</Priority>
<Severity>1</Severity>
<AlertMessageId>$MPElement[Name="AlertMessageID00085a22b54848398319e0f40340f33d"]$</AlertMessageId>
<AlertParameters>
<AlertParameter1>$Target/Property[Type="System!System.Entity"]/DisplayName$</AlertParameter1>
<AlertParameter2>$Target/Property[Type="MSA.System"]/PrimaryIP$</AlertParameter2>
<AlertParameter3>$Target/Property[Type="MSA.System"]/SecondaryIP$</AlertParameter3>
<AlertParameter4>$Data/Property[@Name='severity']$</AlertParameter4>
<AlertParameter5>$Data/Property[@Name='message']$</AlertParameter5>
</AlertParameters>
</WriteAction>
</WriteActions>
</Rule>