Knowledge Article: ID B0EA0D001: I/O module %d POST timeout.

Description

The specified I/O module is taking too long to complete POST.

Causes

During power on, the specified I/O Module is powered on and runs through the POST (power on self test).

Implications

When the POST takes longer than normal, this event is generated.

Resolutions

The I/O module may still be in the process of booting. Therefore, if you do not see a recovery message within 15 minutes, perform these steps:

  1. Attempt to restart the I/O module, and specify the extended POST process to receive a more specific error code.
  2. Perform a service-level reset of the I/O module, which restarts the I/O module.
  3. Reinstall the same level of firmware
  4. Replace the I/O module.

Additional information

To find additional troubleshooting help, visit the "IBM Support & downloads" Web site. At "IBM Support Portal: Quick start" page, select Browse for "Choose your products", select your Chassis from PureFlex System under the Hardware list, and "Troubleshoot" for "Choose your page", then select "Continue" for "See your results". To narrow the results, search with keywords that are related to this article, such as "fail", "Chassis", etc. in the "Search support" field at the right panel.

To download the latest firmware or drivers, visit the "Fix Central" Web site, select "PureSystems" for "Product Group" (from the pull-down lists), select your product for "Product" (from the pull-down lists), select your product machine type for "Product" (from the pull-down lists), and select your operating system for "Operating system" (from the pull-down lists). You can refine the search by selecting the category of the download of your interest from the "Refine results" list.