Config Param Change HTTP Mark Connect Requests Invalid State

ComTrade.Citrix.NetScaler.Monitoring.Appliance.ConfigParamChange.HTTP_markconnreqinval.Rule (Rule)

Monitors change of NetScaler HTTP settings, whether to mark CONNECT requests as invalid.

Knowledge Base article:

Summary

This rule monitors change of Citrix NetScaler configuration parameter, whether to mark CONNECT requests as invalid.

Default value: OFF

Possible values = ON, OFF.

This rule is disabled by default.

Configuration

The following configuration parameters are customizable:

IntervalSeconds - The recurring interval of time in seconds in which to run the script, the default value is set to 900 seconds.
SyncTime - The synchronization time specified by using a 24-hour format. No default value specified.
CacheExpirationFactor - Cache expiration factor. Default value is 1.0.
Debug - When true writes more info in events log. Default value is false.
Priority - Alert priority. Default value is 0.
Severity - Alert severity. Default value is 0.

Element properties:

Target

ComTrade.Citrix.NetScaler.Appliance

Category

PerformanceCollection

Enabled

False

Alert Generate

True

Alert Severity

Information

Alert Priority

Low

Remotable

True

Alert Message

Config Param Change HTTP Mark Connect Requests Invalid State

Citrix NetScaler HTTP configuration settings, mark connect requests invalid (markconnreqinval) parameter has been changed to {0} in NetScaler Appliance {1} (0 represents DISABLED and 1 represents ENABLED state.).

Member Modules:

ID	Module Type	TypeId	RunAs
DS	DataSource	ComTrade.Citrix.NetScaler.Monitoring.Generic.DeltaValueChangeMapped.DS	Default
Alert	WriteAction	System.Health.GenerateAlert	Default
WADataWareHouseDB	WriteAction	Microsoft.SystemCenter.DataWarehouse.PublishPerformanceData	Default
WAOperationsManagerDB	WriteAction	Microsoft.SystemCenter.CollectPerformanceData	Default