Dell Remote Access : Storage : Temperature is in critical state

Dell.iDRAC7.SNMPTrap.4209 (Rule)

Knowledge Base article:

Summary

Temperature critical state alert

Causes

Temperature has generated critical alert. Probable causes and corresponding resolutions for this condition are:

Cause	Resolutions
<tempsensor name> has exceeded the maximum failure threshold.	Check for factors that may cause overheating. For example, verify that the enclosure fan is working. You should also check the thermostat settings and examine whether the enclosure is located near a heat source. Make sure the enclosure has enough ventilation and that the room temperature is not too hot. Refer to the enclosure documentation for more diagnostic information.
<tempsensor name> has crossed the minimum failure threshold.	Check whether the thermostat setting is too low and whether the room temperature is too cool.
<Temp Sensor Name> has failed.	Replace the device.

Resolutions

Additional information on this issue may be available. Launch the DRAC or OMSA Console to debug further.

Element properties:

Target

Dell.RemoteAccess.iDRAC7

Category

AvailabilityHealth

Enabled

True

Alert Generate

True

Alert Severity

Error

Alert Priority

Normal

Remotable

True

Alert Message

Dell Remote Access : Storage : Temperature is in critical state

{0}

Member Modules:

ID	Module Type	TypeId	RunAs
DS	DataSource	Dell.SNMPTrap.DSMT	Default
Alert	WriteAction	System.Health.GenerateAlert	Default

Source Code:

<Rule ID="Dell.iDRAC7.SNMPTrap.4209" Enabled="true" Target="DAD!Dell.RemoteAccess.iDRAC7" ConfirmDelivery="false" Remotable="true" Priority="Normal" DiscardLevel="100">

  <Category>AvailabilityHealth</Category>

  <DataSources>

    <DataSource ID="DS" TypeID="Dell.SNMPTrap.DSMT">

      <IP>$Target/Property[Type="DAD!Dell.RemoteAccess.RAC"]/IPAddress$</IP>

      <CommunityString>$Target/Property[Type="DAD!Dell.RemoteAccess.RAC"]/CommunityString$</CommunityString>

      <AllTraps>false</AllTraps>

      <OIDProps>

        <OIDProp>.1.3.6.1.4.1.674.10892.5.3.2.2.0.4209</OIDProp>

      </OIDProps>

      <EventOriginId>$Target/Id$</EventOriginId>

      <PublisherId>$Target/Id$</PublisherId>

      <PublisherName>iDRAC</PublisherName>

      <Channel>SnmpEvent</Channel>

      <LoggingComputer/>

      <EventNumber>4209</EventNumber>

      <EventCategory>5</EventCategory>

      <EventLevel>10</EventLevel>

      <UserName/>

      <Params/>

    </DataSource>

  </DataSources>

  <WriteActions>

    <WriteAction ID="Alert" TypeID="SystemHealth!System.Health.GenerateAlert">

      <Priority>1</Priority>

      <Severity>2</Severity>

      <AlertName/>

      <AlertDescription/>

      <AlertOwner/>

      <AlertMessageId>$MPElement[Name="Dell.iDRAC7.SNMPTrap.4209.Rule"]$</AlertMessageId>

      <AlertParameters>

        <AlertParameter1>$Data/EventData/DataItem/Property[@Name="drsAlertMessage"]$</AlertParameter1>

      </AlertParameters>

      <Suppression>

        <SuppressionValue>$Data/EventDisplayNumber$</SuppressionValue>

        <SuppressionValue>$Data/Channel$</SuppressionValue>

        <SuppressionValue>$Data/PublisherName$</SuppressionValue>

        <SuppressionValue>$Data/LoggingComputer$</SuppressionValue>

        <SuppressionValue>$Data/EventCategory$</SuppressionValue>

        <SuppressionValue>$Data/EventLevel$</SuppressionValue>

        <SuppressionValue>$Data/UserName$</SuppressionValue>

        <SuppressionValue>$Data/EventNumber$</SuppressionValue>

        <SuppressionValue>$Data/EventData/DataItem/Property[@Name="drsAlertMessageID"]$</SuppressionValue>

        <SuppressionValue>$Data/EventData/DataItem/Property[@Name="drsAlertFQDD"]$</SuppressionValue>

        <SuppressionValue>$Data/EventData/DataItem/Property[@Name="drsAlertCurrentStatus"]$</SuppressionValue>

        <SuppressionValue>$Data/EventData/DataItem/Property[@Name="drsSystemServiceTag"]$</SuppressionValue>

      </Suppression>

      <Custom1>Alert Message ID = $Data/EventData/DataItem/Property[@Name="drsAlertMessageID"]$ </Custom1>

      <Custom2>Alert Message = $Data/EventData/DataItem/Property[@Name="drsAlertMessage"]$ </Custom2>

      <Custom3>Alert Status = $Data/EventData/DataItem/Property[@Name="drsAlertCurrentStatus"]$ </Custom3>

      <Custom4>Alert Service Tag = $Data/EventData/DataItem/Property[@Name="drsSystemServiceTag"]$ </Custom4>

      <Custom5>Alert FQDN = $Data/EventData/DataItem/Property[@Name="drsAlertFQDN"]$ </Custom5>

      <Custom6>Alert FQDD = $Data/EventData/DataItem/Property[@Name="drsAlertFQDD"]$ </Custom6>

      <Custom7/>

      <Custom8/>

      <Custom9/>

      <Custom10/>

    </WriteAction>

  </WriteActions>

</Rule>