Legacy PCI Master Abort
EE_CIM_1179808: PCI Master Abort %1
The following problem causes this event
The transaction of a master was terminated with Master-Abort on a PCI bus. Most likely reasons are plugged PCI cards (e.g. RAID controller). Onboard components can also cause this error.
Restart system
Replace affected PCI device
To view the details of the problem:
Launch ServerView Remote Management iRMC
Target | Fujitsu.Servers.PRIMERGY.ESXi.Server | ||
Category | EventCollection | ||
Enabled | True | ||
Alert Generate | True | ||
Alert Severity | Error | ||
Alert Priority | High | ||
Remotable | True | ||
Alert Message |
|
ID | Module Type | TypeId | RunAs |
---|---|---|---|
EventDS | DataSource | Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource | Default |
Alert | WriteAction | System.Health.GenerateAlert | Default |
<Rule ID="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.1179808" Enabled="true" Target="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.Server" ConfirmDelivery="true" Remotable="true" Priority="Normal" DiscardLevel="100">
<Category>EventCollection</Category>
<DataSources>
<DataSource ID="EventDS" TypeID="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource">
<IntervalSeconds>300</IntervalSeconds>
<HostServer>$Target/Host/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.HostServer"]/PrincipalName$</HostServer>
<IPAddress>$Target/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.Server"]/IPAddress$</IPAddress>
<ErrorCode>1179808</ErrorCode>
</DataSource>
</DataSources>
<WriteActions>
<WriteAction ID="Alert" TypeID="SystemHealth!System.Health.GenerateAlert">
<Priority>2</Priority>
<Severity>2</Severity>
<AlertMessageId>$MPElement[Name="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.1179808.AlertMessage"]$</AlertMessageId>
<AlertParameters>
<AlertParameter1>$Data/Property[@Name='Date']$</AlertParameter1>
<AlertParameter2>$Data/Property[@Name='Name']$</AlertParameter2>
<AlertParameter3>$Data/Property[@Name='Details']$</AlertParameter3>
</AlertParameters>
<Suppression>
<SuppressionValue>$Data/Property[@Name='ErrorCode']$</SuppressionValue>
</Suppression>
</WriteAction>
</WriteActions>
</Rule>