Disk on SATA controller failed
EE_CIM_1769510: SATA(%1:%2:%3) failed
The following problem causes this event
ServerView RAID reported hard disk status 'failed'
Please refer to ServerView RAID front end and log files for details
If affected hard disk was manually set offline this is only informational and the hard disk can be set online.
Replace the affected hard disk.
If the recent status of the hard disk was hot spare, manually set the hard disk to hot spare again
Check the cable or the backplace
To view the details of the problem:
Launch ServerView Remote Management iRMC
Target | Fujitsu.Servers.PRIMERGY.ESXi.Server | ||
Category | EventCollection | ||
Enabled | True | ||
Alert Generate | True | ||
Alert Severity | Error | ||
Alert Priority | High | ||
Remotable | True | ||
Alert Message |
|
ID | Module Type | TypeId | RunAs |
---|---|---|---|
EventDS | DataSource | Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource | Default |
Alert | WriteAction | System.Health.GenerateAlert | Default |
<Rule ID="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.1769510" Enabled="true" Target="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.Server" ConfirmDelivery="true" Remotable="true" Priority="Normal" DiscardLevel="100">
<Category>EventCollection</Category>
<DataSources>
<DataSource ID="EventDS" TypeID="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource">
<IntervalSeconds>300</IntervalSeconds>
<HostServer>$Target/Host/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.HostServer"]/PrincipalName$</HostServer>
<IPAddress>$Target/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.Server"]/IPAddress$</IPAddress>
<ErrorCode>1769510</ErrorCode>
</DataSource>
</DataSources>
<WriteActions>
<WriteAction ID="Alert" TypeID="SystemHealth!System.Health.GenerateAlert">
<Priority>2</Priority>
<Severity>2</Severity>
<AlertMessageId>$MPElement[Name="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.1769510.AlertMessage"]$</AlertMessageId>
<AlertParameters>
<AlertParameter1>$Data/Property[@Name='Date']$</AlertParameter1>
<AlertParameter2>$Data/Property[@Name='Name']$</AlertParameter2>
<AlertParameter3>$Data/Property[@Name='Details']$</AlertParameter3>
</AlertParameters>
<Suppression>
<SuppressionValue>$Data/Property[@Name='ErrorCode']$</SuppressionValue>
</Suppression>
</WriteAction>
</WriteActions>
</Rule>