Power unit redundancy lost
EE_CIM_458757: PSU red down
The following problem causes this event
At least one redundant power supply failed. System is still working but redundancy is lost.
Verify that the primary power connectors are fully plugged into all installed power supply units.
Check status of power supplies and replace defective power supply if necessary
Verify that your power provider did not have any interruptions.
To view the details of the problem:
Launch ServerView Remote Management iRMC
Target | Fujitsu.Servers.PRIMERGY.ESXi.Server | ||
Category | EventCollection | ||
Enabled | True | ||
Alert Generate | True | ||
Alert Severity | Warning | ||
Alert Priority | High | ||
Remotable | True | ||
Alert Message |
|
ID | Module Type | TypeId | RunAs |
---|---|---|---|
EventDS | DataSource | Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource | Default |
Alert | WriteAction | System.Health.GenerateAlert | Default |
<Rule ID="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.458757" Enabled="true" Target="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.Server" ConfirmDelivery="true" Remotable="true" Priority="Normal" DiscardLevel="100">
<Category>EventCollection</Category>
<DataSources>
<DataSource ID="EventDS" TypeID="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource">
<IntervalSeconds>300</IntervalSeconds>
<HostServer>$Target/Host/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.HostServer"]/PrincipalName$</HostServer>
<IPAddress>$Target/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.Server"]/IPAddress$</IPAddress>
<ErrorCode>458757</ErrorCode>
</DataSource>
</DataSources>
<WriteActions>
<WriteAction ID="Alert" TypeID="SystemHealth!System.Health.GenerateAlert">
<Priority>2</Priority>
<Severity>1</Severity>
<AlertMessageId>$MPElement[Name="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.458757.AlertMessage"]$</AlertMessageId>
<AlertParameters>
<AlertParameter1>$Data/Property[@Name='Date']$</AlertParameter1>
<AlertParameter2>$Data/Property[@Name='Name']$</AlertParameter2>
<AlertParameter3>$Data/Property[@Name='Details']$</AlertParameter3>
</AlertParameters>
<Suppression>
<SuppressionValue>$Data/Property[@Name='ErrorCode']$</SuppressionValue>
</Suppression>
</WriteAction>
</WriteActions>
</Rule>