POST - Unsupported memory size detected
EE_CIM_589878: BIOS POST MEM size
The following problem causes this event
Installed memory size not supported on system
Check if correct memory modules are populated. If not replace incorrect modules
Enable the memory modules in BIOS setup
To view the details of the problem:
Launch ServerView Remote Management iRMC
Target | Fujitsu.Servers.PRIMERGY.ESXi.Server | ||
Category | EventCollection | ||
Enabled | True | ||
Alert Generate | True | ||
Alert Severity | Warning | ||
Alert Priority | High | ||
Remotable | True | ||
Alert Message |
|
ID | Module Type | TypeId | RunAs |
---|---|---|---|
EventDS | DataSource | Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource | Default |
Alert | WriteAction | System.Health.GenerateAlert | Default |
<Rule ID="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.589878" Enabled="true" Target="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.Server" ConfirmDelivery="true" Remotable="true" Priority="Normal" DiscardLevel="100">
<Category>EventCollection</Category>
<DataSources>
<DataSource ID="EventDS" TypeID="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource">
<IntervalSeconds>300</IntervalSeconds>
<HostServer>$Target/Host/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.HostServer"]/PrincipalName$</HostServer>
<IPAddress>$Target/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.Server"]/IPAddress$</IPAddress>
<ErrorCode>589878</ErrorCode>
</DataSource>
</DataSources>
<WriteActions>
<WriteAction ID="Alert" TypeID="SystemHealth!System.Health.GenerateAlert">
<Priority>2</Priority>
<Severity>1</Severity>
<AlertMessageId>$MPElement[Name="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.589878.AlertMessage"]$</AlertMessageId>
<AlertParameters>
<AlertParameter1>$Data/Property[@Name='Date']$</AlertParameter1>
<AlertParameter2>$Data/Property[@Name='Name']$</AlertParameter2>
<AlertParameter3>$Data/Property[@Name='Details']$</AlertParameter3>
</AlertParameters>
<Suppression>
<SuppressionValue>$Data/Property[@Name='ErrorCode']$</SuppressionValue>
</Suppression>
</WriteAction>
</WriteActions>
</Rule>