I2C bus access problems exceeded the warning level
EE_CIM_655377: %1 is High
The following problem causes this event
The number of failing I2C bus accesses has exceeded the warning level.
Check if the I2C bus cables are connected correctly
Replace I2C device
Replace system board
To view the details of the problem:
Launch ServerView Remote Management iRMC
Target | Fujitsu.Servers.PRIMERGY.ESXi.Server | ||
Category | EventCollection | ||
Enabled | True | ||
Alert Generate | True | ||
Alert Severity | Warning | ||
Alert Priority | High | ||
Remotable | True | ||
Alert Message |
|
ID | Module Type | TypeId | RunAs |
---|---|---|---|
EventDS | DataSource | Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource | Default |
Alert | WriteAction | System.Health.GenerateAlert | Default |
<Rule ID="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.655377" Enabled="true" Target="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.Server" ConfirmDelivery="true" Remotable="true" Priority="Normal" DiscardLevel="100">
<Category>EventCollection</Category>
<DataSources>
<DataSource ID="EventDS" TypeID="FujitsuESXi!Fujitsu.Servers.PRIMERGY.ESXi.CIMIndications.ErrorCode.DataSource">
<IntervalSeconds>300</IntervalSeconds>
<HostServer>$Target/Host/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.HostServer"]/PrincipalName$</HostServer>
<IPAddress>$Target/Host/Property[Type="FTSESXSEED!Fujitsu.Servers.PRIMERGY.ESXiSeed.Server"]/IPAddress$</IPAddress>
<ErrorCode>655377</ErrorCode>
</DataSource>
</DataSources>
<WriteActions>
<WriteAction ID="Alert" TypeID="SystemHealth!System.Health.GenerateAlert">
<Priority>2</Priority>
<Severity>1</Severity>
<AlertMessageId>$MPElement[Name="Fujitsu.Servers.PRIMERGY.ESXi.EECIM.Alerts.655377.AlertMessage"]$</AlertMessageId>
<AlertParameters>
<AlertParameter1>$Data/Property[@Name='Date']$</AlertParameter1>
<AlertParameter2>$Data/Property[@Name='Name']$</AlertParameter2>
<AlertParameter3>$Data/Property[@Name='Details']$</AlertParameter3>
</AlertParameters>
<Suppression>
<SuppressionValue>$Data/Property[@Name='ErrorCode']$</SuppressionValue>
</Suppression>
</WriteAction>
</WriteActions>
</Rule>